Main Article Content

Abstract

This article describes the research result of the effect of adding fly ash and water concentration of clay on red bricks’ compressive strength. Fisis characteristic and bricks’ compressive strength is according to SNI 15-2094-2000. Variation of fly ash that were used were 5%, 10%, 15%, 20%, 25%, and 30% from the weight of clay. Adding water concentration was based on three criterions of mortar clay condition, namely hard, normal, and soft. Hardmortar clayis a condition of the clay mixture which used less water than the normal mixture. Normal mixture is a condition ofthe clay mixture which usedwater based on usual concentration in brick factory. Soft mixture is a condition ofthe clay mixture that used much water than normal mixture. In this research, there are 8 sample for normal bricks and there are 144 sample for variation bricks. The optimum value of compressive strength for hard and normal mixture of variation bricks were obtained in 10% of fly ash variation which increased 33,59%, and 2,82% from normal bricks. Compressive strength for soft mixture of bricks was obtained in 5% of fly ash variation which increased 28,25% from normal bricks.

Article Details

How to Cite
Astriani, N., Elhusna, E., & Wahyuni, A. S. (2019). PENGARUH PENAMBAHAN FLY ASH DAN KONDISI ADUKAN TANAH LIAT TERHADAP KUAT TEKAN BATA MERAH. Inersia: Jurnal Teknik Sipil, 9(2), 33–38. https://doi.org/10.33369/ijts.9.2.33-38

References

  1. Abdurrohmansyah, Adha, I., dan Ali, H. 2015. Studi Kuat Tekan Batu Bata
  2. menggunakan Bahan Additive (Abu Sekam Padi, Abu Ampas Tebu dan Fly Ash) Berdasarkan Spesifikasi Standar Nasional Indonesia (SNI), JRSDD Vol.3. No.3. Jurusan Teknik Sipil. Fakultas Teknik. Universitas Lampung.
  3. Dinata, M. T., Adha, I., dan Setyanto. 2013. Studi Pengaruh Lama Waktu Proses Pembakaran terhadap Kuat Tekan Batu Bata setelah Penambahan Bahan Additive ISS 2500 (Ionic Soil Stabilizer). JRSDD Vol.1. No.1. Jurusan Teknik Sipil. Fakultas Teknik. Universitas Lampung.
  4. Huda, M., dan Hastuti, E. 2012. Pengaruh Temperatur Pembakaran dan Penambahan Abu terhadap Kualitas Batu Bata. Jurnal Neutrino Vol.4. No.2. Jurusan Fisika. Fakultas Sains dan Teknologi. UIN Maliki, Malang.
  5. SNI 15-2094-2000. Bata Merah Pejal untuk Pasangan Dinding. BSN.
  6. Suseno, H., Prastumi., Susanti, L., dan Setyowulan, D. 2012. Pengaruh Penggunaan Bottom Ash sebagai Pengganti Tanah Liat pada Campuran Bata terhadap Kuat Tekan Bata. Jurnal Rekayasa Sipil Vol.6. No.3.
  7. Jurusan Teknik Sipil. Fakultas Teknik. Universitas Brawijaya, Malang.