Article Sidebar

Submitted
December 16, 2019
Accepted
December 16, 2019
Published
December 20, 2019
Download
PDF
Statistic
Read Counter : 90 Download : 131

Main Article Content

Abstract

Screw turbine for a micro hydro power generator (PLTMH) is to utilize  water flow as electricity generator by screw rotation. The screw was made in two parts, each consists of shaft and blade. The dimension (mm) was 1300 length, 165.5 diameter of shaft axis and 200 blade height with 5 thickness. The first part was different from the second in number and pitch of the blades. The first consists of 5 blade plates by 260 pitch, the second one 7 blades by 185.7 pitch. The fabrication of the screw was completed through series of processes, i.e. plate cutting, plate flatening, pressing, rolling, welding, and balancing. The first part costed Rp. 12.780.000 and the second one Rp. 13.430.000.

Keywords

Screw Turbines Geometry Design Manufacturing Costs Estimation

Article Details

License
Lisensi Creative Commons
Ciptaan disebarluaskan di bawah Lisensi Creative Commons Atribusi-BerbagiSerupa 4.0 Internasional.
Author Biographies

Hendra Hendra, Mechanical Engineering University of Bengkulu

Manufacturing

Filo C Surbakti, Mechanical Engineering University of Bengkulu

Mechanical Engineering

References

  1. Havendri A, Hendro L. 2009. Perancangan Dan Realisasi Model Prototipe Turbin Air Type Screw
  2. Rorres C. 1998. The Turn of the Screw: Optimal Design of An Archimedes Screw, Journal of Hydraulic Engineering. Philadelphia.
  3. Sugiarto, Yusron. 2012. Modul Dasar Proses Pemotongan Logam. Malang: Universitas Brawijaya.
  4. Bambang Y, Yul H, Lisdiyanti. 2012. Pengaruh Debit Aliran Dan Kemiringan Poros Turbin Ulir Pada Pembangkit Listrik Tenaga MikroHidro. Kulon Progo: Universitas Gadjah Mada.
  5. Reza, Ali. Muhammad MS. Yasir S. 2013. Modeling Of Archimedes Turbine For Low Head Hydro Power Plant In Simulink Matlab. Lahore Pakistan: International Journal of Engineering Research & Technology
  6. Rohim, Taufik. 2001. Spesifikasi, Metrologi, & Kontrol Kualitas Geometrik. Bandung: Lab. Teknik Produksi Teknik Mesin FTI-ITB.
  7. Wiyono, Teguh. 2010. Sistem Dan Cara Pemotongan Plat. Politeknosains vol. ix no. 1. Surakarta: Teknik Mesin Politeknik Pratama Mulia Surakarta
  8. Groover MP. 2007. Fundamentals of Modern Manufacturing. NY: Wiley, John & Sons.