Article Sidebar

Download
Statistic
Read Counter : 746

Main Article Content

Abstract

This study aims to do the machining process, measure runout using dial indicator on vertical pump shaft and examine one-way anova to see the effect of angles shaft circle section on the result of runout measurement on the pump shaft. The shaft of vertical pump was produced by a lathe machine. Calculating values the cutting speed, calculating points the theoretical machining time, and measuring grade the runout using dial indicator at the angle 0o, 90o, 180o, and 270o with 10 points of measurement. The results of measurement of runout are carried out one-way ANOVA to see the effect of angles on average runout value. The results of measurement showed at the points of A, B, C, G, I, and J describing the value of runout exceeds level of permitted tolerance but the runout values at the point D, E, F, and H showed the value accepted because they were in below  of the tolerable allowance. The one-way ANOVA show that the average runout value at four cross section angles of the pump shaft were the same. The value at different pump shaft cross section angles did not show an effect on average runout value produced.

Keywords

vertical pump shaft runout one way anova

Article Details

License
Lisensi Creative Commons
Ciptaan disebarluaskan di bawah Lisensi Creative Commons Atribusi-BerbagiSerupa 4.0 Internasional.

References

  1. . Tauvana, Ade Irvan. "Alignment coupling dengan metode double dial indicator rim and face". Jurnal Simetris, Vol.9 No.1. 2018.
  2. . Adiwidodo, Satworo. "Pengaruh angular dan parallel misalignment terhadap konsumsi energi pada motor listrik". prosiding sentia Volume 8-Politeknik Negeri Malang.2016.
  3. . Hajar, Ibnu. "Pengaruh tipe bantalan bola pada poros pompa sentrifugal terhadap sinyal getaran". Jurnal Polimesin Volume 16, Nomor 1. Jurusan Teknik Mesin Politeknik Bengkalis-Riau. 2018.
  4. . Hasan, Muhammad Rif’at. "Analisa pengaruh variasi putaran spindel dan variasi gerakan makan terhadap kekasaran permukaan pembubutan dalam material ST.50". Jurusan Teknik Mesin, Universitas Islam Malang. 2017.
  5. . Rohim. Taufiq. “Proses Permesinan”. Institut Teknologi Bandung. 1993.
  6. . Rohim. Taufiq. “Mesin Perkakas”. Institut Teknologi Bandung. 1996.
  7. . Suharto. ”pompa sentrifugal”. Jakarta : Ray press. 2016.
  8. . Kalsi engineering. Shaft deflection, runout, vibration, and axial motion. Www.Kalsi.com/seal-handbook.html. 2019.
  9. . Raupong. "Solusi Pendugaan Komponen Variansi Negatif pada Klasifikasi Satu Arah Data Seimbang untuk Mengetahui Pengaruh Gizi Limbah Sayuran dalam Pakan Terhadap Pertumbuhan Ikan Nila GiftVol. 13, No. 2. 2017.