Main Article Content

Abstract

PT. Pertamina (Persero) Refinery Unit III (RU III) is one of the Refinery Unit Pertamina that it main activity is process crude oil and intermediate product (Alkylfeed, HSDC,slop oil, LOMC, Long residue, Raw PP) into finished product. One of the important tools is Centrifugal Compressor (CENTAX CC 700 MX 3HP). The problem in the compressor is temperature of the fluida is increase but it pressure is decrease.To solve this problem, sandblasting and coating is used in inspection stage. The result from the inspection was compressor had a leak because the O ring was not functioning optimally and the surface was eroded To overcome this matter, coating is done to prevent the compressor surface from corrosion and replacing the O ring according to size.

Keywords

Centrifugal Compressor O Ring Corrosion Coating

Article Details

Author Biographies

Nurbaiti Nurbaiti, Universitas Bengkulu

Program Studi Teknik Mesin

Hendri Van Hoten, Universitas Bengkulu

Program Studi Teknik Mesin

Helmizar Helmizar, Universitas Bengkulu

Program Studi Teknik Mesin

Putra Bismantolo, Universitas Bengkulu

Program Studi Teknik Mesin

Sulistriono Sulistrionio, Universitas Bengkulu

Program Studi Teknik Mesin

References

  1. Jalil, A., Saifuddin dan Fitri, A, “Perawatan pada Labyrinth Kompresor Sentrifugal Kawasaki K2501 A Dengan Metode Failure
  2. Mode And Effect Analysis (Fmea) di PT. Arun Ngl Blang Lancang”.
  3. Jurnal Polimesin (ISSN: 1693-5462). Vol. 14, No. 1, Hal. 32-36. 2016.
  4. Sumantri, A. H.”Analisis RPN Terhadap Keandalan Instrumentasi Kompresor Udara Menggunakan Metode Fmea Di PT. Pertamina (Persero) Refinery Unit II Dumai”. UIN Syarif Kasim Riau, Pekan Baru. 2013.
  5. Sudarwanto, A. A. “Evaluasi Unjuk Kerja Kompresor Reciprocating 32K-102a di Unit Npu PT. Pertamina (Persero) RU-VI Balongan”. STEM
  6. Akamigas, Cepu. 2015